Spring Chickadee

smoothfoam easter chick

Spring is nature’s way of saying, “Let’s Party!” — Robin Williams

Several of my neighbors raise chickens in their backyards. The anticipation of waiting for each little spring chickadee to hatch is behind the inspiration for this spring chick craft project to decorate your Easter table or to celebrate spring in general. It’s also a fun way to use your scraps of spring-themed paper.

You will need:
One 3″ Smoothfoam ball (cut in half)
One 6″ Smoothfoam disc
Two 12″ x 12″ sheets of spring-themed paper
One 1″ circle punch
Tacky glue
2-1/2″ googly eyes
3 yellow pipe cleaners
20″ length of 1″ wide yellow polka dot ribbon
Straight pins, scissors, toothpicks

Punch 60 circles from your spring paper. Working concentrically from the outer edge into the center, glue the circles to the disc, overlapping the circles slightly as you go.

Take three toothpicks and push them deep into the back of the half-ball for the chick’s head. Spread some glue onto the back. Center the head over the disc and push down, allowing the toothpicks to pierce into the half disc. Glue folded paper circles to cover the seam between the half-ball and the disc. NOTE: The head is brown as I had painted it for another project which I never finished. You do not need to paint the head.

Obermeyer-Smoothfoam-chickadee3

Continue to glue the circles to the head the same way as the disc, overlapping each circle slightly like feathers.

Obermeyer-chickadee5

Bend two of the pipe cleaners into feet by bending a zigzag in the middle of it and the holding the ends together and twisting. Use your scissors to pierce two holes at the base of the disc and push the twisted end of the feet into each hole.

Obermeyer-Smoothfoam-Chickee copy

Begin pinning and gluing the ribbon onto the side of the disc between the feet. Glue the ribbon all the way around the disc. Pin down any bits that seem to be curling.

Eyeball the placement of the googly eyes and glue into place.

Bend half of the third pipe cleaner into a loop. Bend the other half into a second loop and twist the ends together. Pierce a hole with your scissors between the eyes, but slightly down for the beak. Push in the ends of the pipe cleaner beak.

Your chickadee will stand up, though he is a bit wobbly as a newborn chick. If you loved this, be sure to check out all our easy spring crafts!

Leave a Reply

Your email address will not be published. Required fields are marked *