Halloween Tombstone

smoothfoam headstone

Supplies:

Smoothfoam Tombstone
Heat tool
Stencil, painters tape
Acrylic paints
Brayer

First I taped a large 12″ X 12″ Day of the Dead skull stencil on the Smoothfoam tombstone and used a heat tool with a pointed tip to carve out areas on the stencil. Be careful with the tool as it gets very hot and you barely have to touch the Smoothfoam for it to melt away! I like being able to control the depth of the melt. After finishing with the stencil, I went freehand with the heat tool to write RIP.

After I finished carving, I spread some paint on a flat surface and rolled the brayer in it to transfer the paint to the surface of the tombstone. By using a brayer instead of a brush, paint only went on the raised areas. The recessed areas stated white.

Day of the Dead Smoothfoam carving

When I was editiing the photos I thought it would be cool to make one black and white…gives it a creepy look. I am hoping to have several more done in time for Halloween to decorate my whole yard!

black smoothfoam headstone

Leave a Reply

Your email address will not be published. Required fields are marked *