Monogram Wallhanging

Smoothfoam monogram wallhanging

I have been working on a series of variations on the letter W, since that’s the first letter of my last name. I plan to make these into a full-wall installation in my home. Most of the letters are chipboard, wood or plastic, but I wanted something a little different as well. Smoothfoam to the rescue! The best part is that this wallhanging is so lightweight, it can be hung with just a straight pin, making a much smaller hole in your wall.

Supplies:

12″ Smoothfoam Scrapbook Mount
Ink sprays  (I used Clearsnap)
2″ corrugated trim
Patina glaze
Metallic Wax Rusb  (I used Viva Decor)
8 feet of 1″ wide brown grosgrain ribbon
Fabric glue
Foam glue (or general craft glue)
Non-stick craft sheet
45° triangle template
Pencil, scissors, stiff paintbrush, straight pins

Instructions:

Place protective sheet on your work surface because this can get messy. Spritz the Smoothfoam square with a variety of ink colors, adding as much or as little color as desired. Set aside to dry.

ink sprays on smoothfoamCut the corrugated trim into four 12″ lengths to surround the square. Miter the corners with the triangle, marking each cut with the pencil, then trimming with scissors. The corners should fit together like a picture frame.

miteed corners corrugated strips

Paint the corrugate trim with the patina glaze. When it has dried, spray over it randomly with brown ink, then brush the ink in roughly with a stiff brush.

patina glaze and spray ink

When it has dried, rub over it randomly with 2 different shades of metallic wax. Adhere the corrugated trim to the edges of the Smoothfoam sheet.

framed smoothfoam scrapbook mount

Rotate the square so that there are points at the top and bottom. Trace and cut out your initial (or die-cut) from chip board and rub with metallic wax.

metallic wax on painted chipboard

To create the highlight, rub copper and platinum wax onto a scrap of paper larger than the highlight opening. Place the letter over the card stock and use a pencil to mark the sides of the letter. Trim it out and glue it behind the letter.

embellish chipboard letter

Trace and cut (or die-cut) several swirls from chip board and accent with two shades of metallic wax rubs.

chipboard swirlGlue the swirls and the initial to the framed Smoothfoam sheet.

framed smoothfoam sheetUse fabric glue to adhere the ribbon around the bottom and sides of the sheet, keeping the length at the top. Pin the ribbon in place to secure until the glue dries. Tie a loose bow about 6″ above the top point for the the hanger.

Leave a Reply

Your email address will not be published. Required fields are marked *